Salon Technique®
Wet to Dry Straightener with
Ionic Technology
Instruction Booklet
WD5800 / WD5810
Please read these instructions carefully and retain for future reference.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS
FOR YOUR WET TO DRY
STRAIGHTENER WITH IONIC
TECHNOLOGY
• This hairstyler must not come
into contact with water or any
other liquid.
• Always switch off your
hairstyler at the power outlet
and remove the plug when
not in use.
use as the proximity of water
presents a hazard even when
the unit is switched off.
• Do not touch the heating
plates when in use as they
will become extremely hot.
• Do not use this hairstyler if
hair is treated with flammable
products such as hair spray.
• Do not use on hair extensions.
• This styler reaches very high
temperatures very quickly.
Once the styler is plugged in
and switched on, DO NOT
touch with your fingers.
• Do not place on a soft surface
such as a bed or pillow.
During use, rest the styler on
a hard, flat surface.
• Do not store or use your
hairstyler near tubs, basins,
baths or other vessels
containing water or any other
liquid.
• When the hairstyler is used in
the bathroom, unplug it after
DO NOT allow the styler to
touch the skin.
WARNING – The vent holes
must be held away from the
face and head as the steam
escaping through them is
very hot.
If you have any concerns regarding the performance and
contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
1
Sunbeam’s Safety Precautions
Sunbeam are very safety
• Do not use your appliance
with an extension cord
unless this cord has been
checked and tested by a
qualified technician or
service person.
• Always use your appliance
from a power outlet of the
voltage (A.C. only) marked
on the appliance.
conscious when designing
and manufacturing consumer
products, but it is essential
that the product user also
exercise care when using an
electrical appliance. Listed
below are precautions which
are essential for the safe use
of an electrical appliance:
• Read carefully and save all
the instructions provided
with an appliance.
• Always turn the power off
at the power outlet before
you insert or remove a plug.
Remove by grasping the
plug – do not pull on the
cord.
• Turn the power off and
remove the plug when the
appliance is not in use and
before cleaning.
• This appliance is not
intended for use by young
children or infirm persons
unless they have been
adequately supervised
by a responsible adult to
ensure that they can use the
appliance safely.
• Never leave an appliance
unattended while in use.
• Young children should be
supervised to ensure that
they do not play with the
appliance.
2
Sunbeam’s Safety Precautions continued
• Do not use an appliance
for any purpose other than
its intended use.
• Do not place an appliance
on or near a hot gas
flame, electric element or
on a heated oven. Do not
place on top of any other
appliance.
• Do not let the power cord
of an appliance hang over
the edge of a table or
bench top or touch any
hot surface.
• For safety reasons and
to avoid maintenance by
unskilled persons, some
appliances are ‘sealed’
using tamperproof screws.
Such appliances should
always be returned to
the nearest Sunbeam
Appointed Service Centre
for adjustment or repair if
required.
• Do not operate any
electrical appliance with
a damaged cord or after
the appliance has been
dropped or damaged in
any manner. If damage
is suspected, return the
appliance to the nearest
Sunbeam Appointed
Service Centre for
examination, repair or
adjustment.
• For additional protection,
Sunbeam recommend
the use of a residual
current device (RCD) with
a tripping current not
exceeding 30mA in the
electrical circuit supplying
power to your appliances.
• Do not immerse the
appliance in water or
any other liquid unless
recommended.
3
aightener with Ionic Technology
WD5810 – Larger heating plates
Handle
Swivel cord with
3 metre salon length cord
Lock
Ion indicator
Ceramic heating elements
5
Using your Wet to Dry
Straightener with Ionic
Technology
• Before you start to style
your hair, comb through so
that there are no tangles.
• For best results, towel dry
hair. Do not use on dripping
wet hair.
• Plug in to a suitable supply
and switch on. The top
neon green light will come
on. This is the hottest
approximately 5cms wide
and comb or brush it
through. Working from
root to the ends, place the
section between the plates
and squeeze the handle
shut. Be careful not to
touch your skin.
• Hold the styler in place for
3 to 5 seconds depending
on your hair type (3
seconds for fine hair and
up to 5 seconds for thicker
hair).
• Once the hair is heated,
carefully slide the styler
along the direction of
separated hair making sure
that the hair is heated and
straightened all the way to
the ends.
setting at 200 degrees.
• There is no need to pre heat
the styler. The styler will get
very hot very quickly so do
not touch with your fingers.
• Apply a styling lotion.
We recommend PPS
professional products.
• Beginning at the back,
use clips to section
the hair. Take a section
6
Using your Wet to Dry Straightener with
Ionic Technology continued
• Select another section of
hair and repeat the process
until all the hair has been
straightened.
• Finish with a few drops of
D Frizz Smootheez Serum
from PPS.
• Switch off the appliance
and remove the plug from
the power outlet. Allow
to cool completely before
storing.
• Please note that your styler
can be used on dry hair.
This will reduce the
temperature to 175 degrees
(setting 3).
• Pushing the switch again
will reduce the temperature
to 150 degrees (setting 2).
• Pushing the switch again
will reduce the temperature
further to 130 degrees
(setting 1).
• Pushing the switch again
will turn the unit off.
• To increase the temperature,
switch the unit back on.
Changing the temperature
settings
• Allow 30 seconds for each
setting to reach the correct
temperature.
• When you plug in and
switch on, the styler will
automatically set at the
hottest setting of 200
degrees (setting 4).
• We recommend that
you do not use a higher
temperature than necessary
to straighten your hair. Start
on a lower setting and move
up if required.
• If you wish to use a
lower setting, push the
temperature control switch.
Note: You may hear a hissing
7
Using your Wet to Dry Straightener with
Ionic Technology continued
sound and see steam. This
is normal as the styler dries
your hair.
• For a more choppy look,
choose pieces at random.
Auto off function
Setting 1 = 200°C
Setting 2 = 175°C
Setting 3 = 150°C
Setting 4 = 130°C
• For added safety,
your hairstyler will
automatically switch off
after approximately 45
minutes.
Ionic Technology
• After 44 minutes the LED
will flash to indicate that
you have one minute of
styling left before the
• The built-in ionic generator
automatically produces
a constant stream of
negative ions whenever the
styler is switched on.
appliance switches off.
• If you want to continue
styling, simply switch
off at the socket and then
on again.
• The ion indicator light will
light up whilst your styler
is in use.
Please note that this is an
added safety feature. Always
switch off after use and
unplug from the mains.
Creating Flicks and Curls
• Once the hair is heated, as
you work towards the end
of the section of hair, lift
the styler up and out to
8
create flicks.
Help Line
If you have any additional questions about using the Wet
to Dry Straightener with Ionic Technology, please call the
Sunbeam help line in Australia on 1800 025 059. In New
Zealand, please call 0800 786 232.
Care and Cleaning
• After use, remove the plug
from the power outlet and
allow the hairstyler to cool
before storing.
• Do not wrap the cord
around the appliance
when not in use.
• Store in a dry place.
• The ceramic plates and
the outside of the styler
can be wiped with a soft
cloth.
9
Consumer Hotline
Australia
1800 025 059
New Zealand
0800 786 232
‘Sunbeam’, is a registered trademark of Sunbeam Corporation.
Made in China. Due to minor changes in design or otherwise, the product
may differ from the one shown in this leaflet. Backed by Sunbeam‘s 2 Year
Replacement Guarantee and National Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2005.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
Sunbeam Corporation is a division of GUD Holdings Ltd.
For more information or advice on this or any other Sunbeam appliance, visit
www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Australia 1800 025 059 New Zealand 0800 786 232.
08/05
is a registered Trademark of Sunbeam
Corporation Limited. ACN 000 006 771.
© Sunbeam Corporation Limited 2005.
|