Burr Grinder
Automatic burr grinder with 17-position
grind selector
Instruction Booklet
EM0430
Please read these instructions carefully
and retain for future reference.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR
SUNBEAM BURR GRINDER.
• Check the grinding bowl for the presence of
foreign objects before using.
• Always operate the grinder with the ground
coffee container properly inserted in the
grinder.
• When grinding make sure the lid of the ground
coffee container is secured. If this lid is not
securely in place, ground coffee can blow out
of the grinder spout during grinding and create
a mess on your benchtop.
• Do not place your hand in or near the burrs
while the grinder is in operation.
• Always place the unit on a flat, level surface.
• Switch off and unplug at power point before
cleaning.
• Do not attempt to re-grind ground coffee.
Sunbeam are very safety conscious when
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• For safety reasons and to avoid maintenance
by unskilled persons, some appliances are
‘sealed’ using tamperproof screws. Such
appliances should always be returned to the
nearest Sunbeam Appointed Service Centre
for adjustment or repair if required.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• Close supervision is necessary when your
appliance is being used near children or
infirm persons.
• Never leave an appliance unattended while
in use.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
dropped or damaged in any manner. If damage
is suspected, return the appliance to the
nearest Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
• Young children should be supervised to ensure
that they do not play with the appliance.
If you have any concerns regarding the performance and use of your appliance,
Ensure the above safety precautions are understood.
1
Features of your Sunbeam
Burr Grinder
Grinding bowl with lid
Coffee beans may be ground by pouring them
directly into the grinding bowl, ideal when
using alternative styles of beans and trialing
new blends.
Burr grinding wheel
Removable burr grinding wheel for easy
cleaning.
Grind fineness selector
17-position grind selector grinds beans to the
correct fineness for espresso, drip, French
Press and percolators.
Non-slip feet
Keeps the grinder stable on the benchtop
during grinding.
2
Portion-control container with lid
Allows you to grind the correct amount of
beans for the required cups of coffee. Simply
choose any amount of coffee from 2 to 16
cups and the beans are automatically
dispensed into the grinding bowl. Also
removable for storing beans inside.
Grind button
Once activated, the electronic bean sensor
allows the grinder to continue grinding as
long as there are beans in the grinding bowl,
then stops automatically.
Ground coffee container
Large ground coffee container is easy to
remove, making it simple for pouring out the
coffee.
Illuminated On/Off power switch
3
Using your Sunbeam Burr Grinder
Before using your Sunbeam Burr Grinder,
wipe the base exterior, grinding bowl and
portion-control container clean with a damp
cloth. Wash the grinding bowl lid, portion-
control container lid and ground coffee
container and its lid in warm soapy water.
Allow to dry completely before use.
7. Push the ‘GRIND’ button for 2 seconds
and release. The Sunbeam Burr Grinder
will grind all the beans in the grinding
bowl, once empty it will then stop
automatically.
8. Turn the power switch on the Sunbeam
Burr Grinder to ‘OFF’.
Note: Do not immerse the upper burr grinding
wheel in water or any other liquid.
9. Remove the lid to the grinding bowl and
fill bowl with 3 to 4 scoops of coffee
beans. Replace the lid.
Note: Do not place any parts of the Sunbeam
Burr Grinder in the dishwasher.
10.Set the grind fineness selector to number
‘4’, this is to ensure that the upper burr
grinding wheel is moving properly.
For first-time grinding
Important: During manufacturing, the upper
burr grinding wheel is positioned so that it is
very close to the lower burr grinding disk. To
ensure the grinder performs properly, proceed
as follows:
11.Turn the power switch on the Sunbeam
Burr Grinder to ‘ON’.
12.Push the ‘GRIND’ button for 2 seconds
and release.
Note: Your Sunbeam Burr Grinder is now
prepared to be used on a regular basis.
1. Place the Sunbeam Burr Grinder on a dry,
level surface.
2. Check to make sure that the grinding
bowl is free of any foreign objects and
that it is completely clean and dry.
Grinding
1. Place the Sunbeam Burr Grinder on a dry,
level surface.
3. Set the grind fineness selector to number
‘9’.
2. Check to make sure that the grinding bowl
is free of any foreign objects and that it is
completely clean and dry.
4. Fill the grinding bowl with 3 to 4 scoops
of coffee beans and position the grinding
bowl lid to the bowl.
5. Plug the power cord into a 230-240V AC
power outlet and switch the power on.
6. Turn the power switch on the Sunbeam
Burr Grinder to ‘ON’, the switch will
illuminate.
Note: Ensure that the lid on the grinding bowl
is secure and in place.
4
Using your Sunbeam Burr Grinder (continued)
Using the portion-control container;
3. Ensure that the lid of the grinding bowl is
removed.
Figure 2
4. Position the portion-control container
directly on top of the grinding bowl. To
lock into position turn the portion-control
container clockwise, see figure 1.
Figure 1
Using the grinding bowl
6. Alternatively coffee beans can be poured
directly into the grinding bowl. Replace
the lid.
7. Set the grind fineness selector, see figure 3.
Figure 3
5. Pour coffee beans into the portion-control
container and position the lid. Slowly turn
the lid of the portion-control container, in
a clockwise direction, with each turn or
click enough beans for 2 cups of coffee
are dispensed into the grinding bowl, see
figure 2. The grinding bowl holds enough
beans for up to 16 cups of coffee.
5
Using your Sunbeam Burr Grinder (continued)
8. Plug the power cord into a 230-240V AC
power outlet and switch the power on.
11.While still positioned in the grinder, tap
the ground coffee container a few times,
this allows the ground coffee to settle
down into the container. Now, slowly
remove the container from the Sunbeam
Burr Grinder, see figure 5. Before
removing the lid to the ground coffee
container, tap the container again a few
times to settle more of the ground coffee,
see figure 6.
9. Turn the power switch on the Sunbeam
Burr Grinder to ‘ON’, the switch will
illuminate, see figure 4.
Figure 4
Figure 5
Note: Ensure that the lid on the portion-
control container or grinding bowl is secure
and in place.
10.Push the ‘GRIND’ button for 2 seconds
and release. The Sunbeam Burr Grinder
will grind all the beans in the grinding
bowl, once empty it will then stop
automatically.
Figure 6
Note: Oily beans may stick together and not
feed into the burrs. This can cause the
automatic sensor to turn off the grinding
action. Should this occur, just tap the
housing of the Sunbeam Burr Grinder a few
times to loosen up the beans and push the
‘GRIND’ button again to resume grinding.
6
Using your Sunbeam Burr Grinder (continued)
12.Turn the power switch on the Sunbeam
Burr Grinder to ‘OFF’, see figure 7.
13.Once the ground coffee container is
emptied, insert the empty ground coffee
container with the lid securely in place
back into the Sunbeam Burr Grinder.
Figure 7
Note: Allow the Sunbeam Burr Grinder to cool
down for 5 to 10 minutes before grinding
again.
7
Guidelines for 17-position grind
fineness selector
The grind fineness selector gives you the
choice of 17 positions, allowing you to find
the perfect grind selection for a superb result
in all styles of coffee machines.
Note: If you grind in the finer settings
(settings from 1 to 3) we recommend
cleaning the ground coffee spout and upper
burr grinding wheel after each grinding
session to avoid clogging. See the Care and
Cleaning section on page 9 for more details.
Note: The finer you select the coffee grind to
be, the longer it will take to grind.
Grind Fineness Selector
Suited Style of Coffee Machine
French Press Coffee Makers
Percolators
8 - 9
4.5 – 6
3.5 – 5
2.5 – 4
1 – 2.5
Non-Pump Espresso (steam/boiler) Machines
Drip Coffee Makers
Pump Espresso Machines
Fully Automatic Coffee Centres
Note: The fineness settings are approximate guidelines. For pump espresso machines and
automatic coffee centres, if your coffee or espresso brews too fast try a lower number setting
than indicated above. If it brews too slowly, try a higher setting than the ones recommended
above.
8
Care and Cleaning
Do not immerse the motor base of the Sunbeam
Burr Grinder in water.
7. Turn the upper burr grinding wheel in a
clockwise direction until it stops, see
figure 9.
Do not place any parts of the Sunbeam Burr
Grinder in the dishwasher.
Figure 9
1. When you have finished grinding, unplug
the grinder from the power outlet.
2. Empty the ground coffee container.
3. The portion-control container and lid, the
separate grinding bowl lid (if used) and
the ground coffee container and its lid
can be washed in warm soapy water.
Rinse and dry thoroughly.
4. With the small brush (provided), brush
away any ground coffee particles from the
ground coffee spout (where the ground
coffee comes out and into the ground
coffee container), see figure 8.
8. Lift the upper burr grinding wheel out of
the grinding bowl. Clean both burrs with
the small brush (provided).
Note: Do not unscrew the upper burr from its
housing.
Figure 8
9. Replace the upper burr grinding wheel
back into position in the grinding bowl
and turn anti-clockwise until the grind
fineness selector points to number ‘9’,
see figure 10.
ground
coffee
spout
Figure10
5. Wipe the base exterior and grinding bowl
clean with a damp cloth.
Removing and cleaning the burr
grinding wheel
Note: Do not immerse the upper burr grinding
wheel in water or any other liquid.
6. Turn the grind fineness selector to
number ‘1’.
9
‘Sunbeam’, is a registered trademark of Sunbeam
Corporation.
Made in China. Due to minor changes in design or
otherwise, the product may differ from the one shown
in this leaflet. Backed by Sunbeam‘s 12 Month
Replacement Guarantee and National Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2003.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
Sunbeam Corporation is a division of GUD Holdings Ltd.
For more information or advice on this or any other
contact the Sunbeam Consumer Service Line.
Australia 1800 025 059
New Zealand (09) 912 0747.
Consumer Hotline
Australia
1800 025 059
New Zealand
(09) 912 0747
is a registered Trademark of Sunbeam
Corporation Limited. ACN 000 006 771.
© Sunbeam Corporation Limited 2003.
|