Quick instructionsSet 55 TV
Set 50 TV
²
´
ƺ
A
¿
B
»
¹
C
·
¸
Ƹ
ƹ
³
Connecting the system components
Plug in one end of the connecting cable
ꢀ
¸
to the socket on your sound source (e.g. television).
or ƹ (not included)
Plug in the other end of the connecting cable to the blue socket
If necessary, use one of the adapters ¹
,
Ƹ
.
¸
ᕤ
on the transmitter.
ꢀ Connect the mains unit ƺ to the transmitter ´ and to the mains.
ꢀ Place the receiver into the transmitter’s charging compartment ².
ꢀ Before you use the rechargeable battery ᕢ for the first time, charge it for at least 14 hours.
ꢀ Adjust the volume of your sound source to a sufficient (medium) level.
Switching on and using the stethoset receiver
ꢀ Turn the volume control ³ in the direction of “ON” until it clicks.
ꢀ First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
ꢀ Use the balance control » to adjust the volume between the left and right ear.
ꢀ If you cannot hear anything through the receiver, increase the volume of your sound source.
Switching off the stethoset receiver
ꢀ To switch the receiver off, turn the volume control ³ in the direction of “OFF” until it clicks.
Charging the stethoset reciever
ꢀ Switch the receiver off. Place the receiver into the transmitter’s charging compartment ² without
exerting too much pressure. With a fully charged battery, the operating time is approx. 9 hours.
For details on the use of the Set 50 TV/Set 55 TV, please refer to the enclosed operating instructions.
Sennheiser electronic GmbH & Co. KG
30900 Wedemark, Germany
Phone +49 (5130) 600 0
Fax +49 (5130) 600 300
Printed in China
Publ. 10/06
517641 / A02
|